Introducing our Unicorn Treat Cup collection! These mini ' Print and Cut" cups make sweet unicorn party favors! Plus using your Silhouette Cameo it only take a few minutes to cut and assemble. Fill them with your favorite small candies. Please read below for the assembly instructions. Each of these 'Print and Cut' design files can be purchased separately from the Silhouette America Design Store.
Each cup is approximately 4.25" tall, 1.5" wide at the base.
- Colour printer & ink
- Strong glue stick or double-sided tape
- White 8.5" by 11" Cardstock (65 lb)
- Silhouette Cameo & Mat
Step1: Align the design in your Silhouette Studio software so that it fits inside your registration guides. Next print the design with the registration marks onto white card stock. Select 'card-stock' as the material in your cut settings, then load your cutting mat with your design into your Silhouette Cameo. Once cut apply double-sided tape or strong glue to the edge of the cup marked 'glue'. Wrap the base of the cup around until it meets with the dotted line. Hold until dry.
Step2: Bend all the tabs on the bottom of the cup inwards and apply double-sided tape or glue. Carefully fit all the tabs into the bottom of the base of the cup. It may help to poke a finger inside the cup to check the tabs are adhered properly to the inside of the cup.
Step3: Gently curl the tabs at the top of the cup inwards using your fingers. Insert small candies or treats. To close the cup hold down all the rounded tabs in the center.
Step 4: Hook the last three tabs together to complete the closure. Voila! Your mini treat cup is ready to gift!
~Thank-you for checking out this design and others! Please note that all of printable designs sold through our Little Luxuries Loft Etsy Shop are in PDF format only, if you wish to purchase Silhouette Studio or SVG design cut files you can do so through the Silhouette America Design Store :)